New protocol supported by AutoTuner!
We are excited to announce the addition of a new protocol to the AutoTuner Tool!
You can now read and write Bosch EDC16C41 ECUs for Nissan and Renault vehicles in BENCH mode. In response to the growing demand for support of older protocols, we are enhancing our tool to optimize performance across a wider range of ECUs.
With AutoTuner, access to these ECUs is possible without needing to open them, offering increased security and efficiency during read and write operations.
Get ready to fully leverage your AutoTuner's capabilities with this new compatibility!
What are the key features
-
Mode: BENCH 🔌
-
MCU: MPC562 🖥️
-
Checksums correction ✅
Brands/engines covered by this release*:
NISSAN : 3.0 DCI / 3.0 VDI
RENAULT : 3.0 DCI / 3.0 dXI
*The list of vehicles may evolve over time.
